Today was the beginning of the cowl fitting. I started by getting the front “ring” of the top and bottom cowl fitting correctly, and the
Category: RV10 Build
Cowl Trimming, part 2
Prop Governor, Fuel Servo, and Filtered Air Box
Alt Air Door
Alt Air and FAB Nose Trimming
Lower cowl work
(RE) drilling the cowl hinges
As I mentioned in an earlier post, I wasn’t happy with the gap I had between the upper and lower cowl halves, so I ordered
Cowl fasteners
Couple things accomplished today. First I installed the nutplates that join the upper and lower cowl halves inside the inlets. And second, I changed out
Baffling beginnings
Tonight, I started fabrication of the engine baffles. Pretty straight forward, and it was fun to get back into some good old fashion aluminum work!
