I began tonight by making a doubler for the transponder antenna, just like I did for the ADSB antenna… this time in the tunnel in
Xpndr Doubler, Wire tying tailcone
Author: Ed
Overhead light cutouts
I only got one thing accomplished today. I cut out all the holes for the overhead lights in the overhead console inserts. I have two
Tailcone stuff
There are a few items that are going to be mounted in the tailcone behind the rear baggage bulkhead: The ELT, the GDL39-R ADSB-IN, a
EGT/CHT Wire Harness
Tonight, I built the harness for the EGT and CHT sensors. I first measured what I would need for lengths of cable for each sensor
Misc FWF
Another hodgepodge of tasks on the FWF. First, since the adel clamps I ordered came in, I was able to finish the last 3 spark
Starter and Alternator Cables
Short night tonight. I finished securing the starter and alternator cables to the engine block with adel clamps, crimped ends on, put on some shrink
FWF Electrical
I started the day today by securing the alternator field wire and the block heater wires to the engine block with adel clamps. But most
Misc FWF stuff
Got a few different things done today. First, I installed the cover plates that close up the holes left by removing the magnetos. I also
Finishing Lightspeed and Building Plug Wires
With pretty much everything for the Lightspeed install behind the panel done, I finished wiring the coil leads. Something happened with the video, and I
More lightspeed wiring
Yup. Back under the panel I go. I think I finally have the box mounting and wire routing how I want it. It’s still a