Another hodgepodge of tasks on the FWF. First, since the adel clamps I ordered came in, I was able to finish the last 3 spark plug wires. I have them all secured well and routed nice and clean. With that, the plug wiring is done!
Next, I made up the drain lines for the fuel pump and the filtered air box. These are just a pair of plastic tubes that are fastened to the lower cowl bracket.
Then, I cleaned up the baffle material. There is a release agent on the material, and it needs to be cleaned off for RTV to stick to it. Once the material was clean, and the rivets I drilled out when running the LSE sensor lines were replaced, I ran a bead of RTV between the baffles and the seal material to get a good airtight seal.
