Category: Cabin Top

Started off with more sanding and filling. Then it was time for something new: cutting out the Aerosport Products headliner shells. These liners are going

Sanding and filling (x2) on the switch pod forward edge today. I also decided to try to make some fiberglass door strut bracket covers. I’m

Started the night with some more sanding on the front surface of the switch pod. Then I went back to the bracket covers. I shaped

The fiberglass covers had cured over night, so I popped them off the molds. They turned out pretty good. Once I had the covers off,

Today was finally time to put the first coat of primer on the cabin top. I feel that I’ve got the surfaces that will be

Yup. Back to sanding and filling. But the end is in sight! The high build primer has cured, and the cabin top looks really good.

I sanded down the epoxy I had applied to fill the last few pinholes. I also really wanted to see how the transition was going

After the last coat of primer, the top is to a point where I could wet sand it out and call it good… however, after

I’m done with the body work on the cabin top!!! Well, the interior, at least. I went a little heavy on the last primer coat

With the gear fairings done, I could focus back on getting the cabin top ready to be installed on the plane. Tonight I prepared and