So I build the landing light mounting plates WAY back when I was working on the wing build, but tonight, I had to cut them
Landing lights and other wing wiring
GPS Antenna and Left Wing Wiring
I got the GPS Antenna coax wires pulled tonight. It was a bit of a pain in the ass to pull 3 RG400 cables up
FWF and Wing Wiring
Few different things going on today. First, I had to replace one of the electrical shunts on the firewall, as I broke a screw off
ADAHRS Mount
Today, I build a mount for the dual Garmin GSU 25 ADAHRS (Air Data and Attitude Heading and Reference System). These redundant boxes take in
Airplane birthday – EJ is ONE!
So even though Ed is in crazy – get the airplane done – airplane mode, we couldn’t miss an opportunity to give EJ a little
Engine Sensor Wiring
Tonight I worked on connecting all the engine sensor wires into the plugs that connect to the Garmin GEA (Garmin Engine Analyzer) 24.
EGT/CHT Sensor Wires COMPLETE
Tonight I finished up the last part of the EGT and CHT sensor install. I crimped ends on the wires I ran from the engine
FWF Sensor Wiring
Today, I ran wires for all the FWF sensors, like the oil pressure, fuel pressure, manifold pressure, oil temp, fuel flow, and the alternator ammeters.
Wiring cleanup
Now that I had the lighting system tested, I was time to clean everything up. I got all the wiring in the overhead tied into
Interior Lighting System, Part 3
Picking up where I left off yesterday, I worked on finishing the LCU. I cut a piece of masonite board to fit to the bottom