Tonight, the flange I had glassed in had cured, so I trimmed that up. Then, since I’ll be installing the pod permanently soon, I bolted the center post on. The instructions have you bolt this on once the cabin top is in place, but I played around with it, and I shouldn’t have an issue sliding the post in position on the fuselage when I install the cabin top.
Next, I positioned and match drilled some holes in the pod panel.
Finally, I filled some voids in the fiberglass flange I had created. Like I stated in the previous post, I should have put down some epoxy/flox mixture before laying the flange fiberglass, but I was able to correct that issue tonight.
