Starter and Alternator Cables November 18, 2014December 26, 2014 Ed FWF, RV10 Build Short night tonight. I finished securing the starter and alternator cables to the engine block with adel clamps, crimped ends on, put on some shrink Read more
Misc FWF November 19, 2014December 26, 2014 Ed FWF, RV10 Build Another hodgepodge of tasks on the FWF. First, since the adel clamps I ordered came in, I was able to finish the last 3 spark Read more
EGT/CHT Wire Harness November 21, 2014December 27, 2014 Ed FWF, RV10 Build Tonight, I built the harness for the EGT and CHT sensors. I first measured what I would need for lengths of cable for each sensor Read more
Tailcone stuff November 27, 2014December 27, 2014 Ed RV10 Build, Wiring There are a few items that are going to be mounted in the tailcone behind the rear baggage bulkhead: The ELT, the GDL39-R ADSB-IN, a Read more
Overhead light cutouts November 30, 2014December 26, 2014 Ed RV10 Build, Wiring I only got one thing accomplished today. I cut out all the holes for the overhead lights in the overhead console inserts. I have two Read more
Xpndr Doubler, Wire tying tailcone December 3, 2014December 27, 2014 Ed RV10 Build, Wiring I began tonight by making a doubler for the transponder antenna, just like I did for the ADSB antenna… this time in the tunnel in Read more
Flap Motor Wiring December 4, 2014December 27, 2014 Ed RV10 Build, Wiring Quick night tonight. I made up a twisted pair of wires for the flap motor, routed them thru the fuse, and connected them up to Read more
Misc tailcone wiring + brake lines December 6, 2014December 27, 2014 Ed RV10 Build, Wiring I started by test fitting the stainless steel lines I had made up from Bonaco. I had to have them cut down a bit to Read more
Tailcone Wiring December 13, 2014December 27, 2014 Ed RV10 Build, Wiring Back into the hole I go! I had to drag myself back into the tailcone to wire tie the pitch trim wires and elt antenna Read more
Magnetometer Install December 14, 2014December 27, 2014 Ed RV10 Build, Wiring Today, I got the magnetometer installed. I’m installing it using the RV10 mounting bracket that I got from Steinair. I think it’s made by Garmin. Read more