In an earlier post, I mentioned that I was installing heat tees that had movable flaps inside them to allow me to send heat to
Heat Tee Servos
Aerosport Products Overhead Console Air Supply
Tonight was a fun night. I got the fresh air ducting that will supply air to the overhead console installed (mostly) in the tailcone. I
Countersinking cabin top
Quick night tonight. I got all the holes in the cabin top countersunk, and the holes in the fuse sides dimpled. The only difference from
Rivet Strips
Tonight, I started by deburring all the holes that were match drilled in the fuse for the cabin top attachment. Then I deburred all the
Starting the Static System
Quick night tonight. I began to install the static ports and lines that will be in the tailcone. For static ports, I’m using the SafeAir1
Aerosport Overhead
As I’ve mentioned before, I’m going to be using the Aerosport overhead console in my build. It’s a single piece of carbon fiber, very stiff,
Rear seat riveting
I’m finishing up a previous section tonight. I’m finally getting around to riveting in the rear seat pans. Before I could do this, I had
Electronic idea exploration
As I’ve mentioned in previous posts, I’ve installed aftermarket heat tee’s in my RV10. This was done to allow Colleen and I to be able
Trimming rear windows
Like the front windscreen, I am using windows from Cee Bailey’s for the rear windows. As I received them, they were pretty close, but did
Windscreen trimming
Instead of the stock windscreen that comes with the kit, and the rest of the transparencies in the plane, I went with a window kit