Category: Wiring

I took a day off of work today so I could focus on getting some good work done on the plane. I’m continuing on with

Picking up where I left off yesterday, I worked on finishing the LCU. I cut a piece of masonite board to fit to the bottom

Now that I had the lighting system tested, I was time to clean everything up. I got all the wiring in the overhead tied into

Today, I ran wires for all the FWF sensors, like the oil pressure, fuel pressure, manifold pressure, oil temp, fuel flow, and the alternator ammeters.

Tonight I finished up the last part of the EGT and CHT sensor install. I crimped ends on the wires I ran from the engine

Tonight I worked on connecting all the engine sensor wires into the plugs that connect to the Garmin GEA (Garmin Engine Analyzer) 24.

Today, I build a mount for the dual Garmin GSU 25 ADAHRS (Air Data and Attitude Heading and Reference System). These redundant boxes take in

Few different things going on today. First, I had to replace one of the electrical shunts on the firewall, as I broke a screw off

I got the GPS Antenna coax wires pulled tonight. It was a bit of a pain in the ass to pull 3 RG400 cables up

So I build the landing light mounting plates WAY back when I was working on the wing build, but tonight, I had to cut them