Category: Wings

Repeat of last night, with the other tank:

I prosealed the tank attach brackets in place on both tanks tonight. This was a little tricky, because you need to make sure there is

After a few days away from the plane, I came back tonight and got the tank attach brackets riveted in place and sealed up. I

Got the fuel vents fabricated and the inboard aft ribs sealed in place.

Just a little bit of time to work on the plane today. Got one of the aft inboard tank ribs riveted in place.

Got the last tank rib riveted in place today. I also got the capacative fuel sensors and wiring installed in the left tank. It’s a

The capacitive sensor plates are all installed and wired. Electrical continuity has been verified between the two plates and the center conductor of the connector,

Today, I cleaned up the inside of the left fuel tank and did another close inspection of all the interior seams.  

Finished riveting up the left baffle, and then continued on the same as the other day, but with the right tank.

Just a short night tonight. I got half of the right baffle riveted in place.