Category: RV10 Build

Tonight, I finished final drilling the elevator skins. Nothing new here, just the same as the other 3 skins. After that, I measured out and

Today I got all the deburring and scuffing done on all the elevator parts. 6 hours worth. It was one of those “just sit down

Another good day of progress on the -10! There are a whole lotta holes in the elevators on this plane, and most of them are

  I had to bust out my non-existent woodworking skills tonight. They were needed to build the clamp/jogs for the trim tabs. The trim tab on

Got back in the shop tonight and managed to knock out most of the fabrication of the elevator trim tabs. There isn’t much to them.

Another few hours spent on the -10, this time deburring all the holes in the trim tab parts. Then there was some dimpling and countersinking.

Today, I turned this pile of parts: Into this pile of parts:    Everything is all ready for riveting.

Tonight, I was able to begin riveting the piles of elevator parts together! I began by assembling the tip ribs and their skins. This was

More riveting on the elevators tonight. Going into this project, I always thought about how much time all this riveting was going to take… but

I decided to try something new tonight. I had a Google “Hang Out” going while I was working on the elevators. Google Hangout is basically