Good. Plane. Living.

The capacitive sensor plates are all installed and wired. Electrical continuity has been verified between the two plates and the center conductor of the connector,

Got the last tank rib riveted in place today. I also got the capacative fuel sensors and wiring installed in the left tank. It’s a

Just a little bit of time to work on the plane today. Got one of the aft inboard tank ribs riveted in place.

Got the fuel vents fabricated and the inboard aft ribs sealed in place.

After a few days away from the plane, I came back tonight and got the tank attach brackets riveted in place and sealed up. I

I prosealed the tank attach brackets in place on both tanks tonight. This was a little tricky, because you need to make sure there is

Repeat of last night, with the other tank:

Got the left tank j-channel stiffener all riveted in and sealed.

Today, I double checked every inch of the sealant on the inside of both tanks. There were a few places where a bubble in the

Finally finished riveting and sealing in the tank ribs.