Today, I got the inner wing skin countersunk where called out in the plans. These are places where the outer skin is backed up by
Author: Ed
Drillin’ some skins
Today, with assistance from my lovely helper Colleen, we get the top wing skins clecoed in place and fully match drilled. I don’t know how
Wing stand construction
The next step in the build process of the wings is to start installing skins. Since this will require access to both sides of both
Rear Wing Spar Complete!
I was able to finish up riveting on the rear wing spar tonight. A quick and easy night!
Rear spar parts primed and riveting started
Like the title says, I prepped and primed all the rear spar parts. I was just going to let them dry, but I decided to
Flyin’ thru the rear spar
The rear spar is going pretty quickly. Today I finished fabbing up the doubler plates, counter sunk, and dimpled everything called out in the plans,
Beginning the rear wing spar
Tonight was one of those fun nights where you get a lot of small steps done relatively quickly. In two hours, I almost finished up
Wing ribs (Section 14): Complete!
I was able to put a bit more time in today and finish up the wing rib section. That means that all of the wing
Rib riveting (now with extra motivation!)
Just got back from Oshkosh AirVenture, and after spending the week with a whole bunch of GREAT RV10 builders, my motivation levels are at an
Rib stuff
Quick catch-up post. (I’m writing this from the future!) Drilled out the holes for wire and air lines in the wing ribs. I’m drilling them