I installed the rear heat SCAT tube. Again, I needed to come up with some custom supports because of the control approach pedals. The rudder
Rear Heat SCAT
Author: Ed
Tunnel work
Started the night by reinstalling the fuel pump. This should be the last time that it needs to get bolted in! Once that was in
This and that
Got a bunch of different things done tonight. First, I started by connecting up the wiring to the Redcube fuel flow sensor. I had the
Wing wiring
Just finishing up some last things in preparation for riveting on the wing bottom skins. I had built some small grounding blocks for local grounding
500th Video!!!
Unfortunately, I really didn’t do anything earth shatteringly interesting. I just reinstalled the landing lights into the freshly painted black Duckworks mounts and screwed them
Landing lights and other wing wiring
So I build the landing light mounting plates WAY back when I was working on the wing build, but tonight, I had to cut them
GPS Antenna and Left Wing Wiring
I got the GPS Antenna coax wires pulled tonight. It was a bit of a pain in the ass to pull 3 RG400 cables up
FWF and Wing Wiring
Few different things going on today. First, I had to replace one of the electrical shunts on the firewall, as I broke a screw off
ADAHRS Mount
Today, I build a mount for the dual Garmin GSU 25 ADAHRS (Air Data and Attitude Heading and Reference System). These redundant boxes take in
Engine Sensor Wiring
Tonight I worked on connecting all the engine sensor wires into the plugs that connect to the Garmin GEA (Garmin Engine Analyzer) 24.