Rear Heat SCAT

Hours Worked = 2

I installed the rear heat SCAT tube. Again, I needed to come up with some custom supports because of the control approach pedals. The rudder pedal arms come down in the tunnel, and the scat tube either needs to run lower than the arms, or between them. I choose to install them between the arms, which meant I needed some support to hold it in place, and not interfere with the rudder action. I ended up making a brace with some angle aluminum and used that to attach an adel clamp to… and clamped the scat tubing in place.

Finally, I installed the front most part of the tunnel cover.

IMG_4838.JPGIMG_4839.JPGIMG_4840.JPGIMG_4841.JPG

Leave a Reply

Your email address will not be published. Required fields are marked *